Setup & Configuration

Step 1: Power and Connect

1. Power the module with a 5V regulated supply.

2. Connect UART RX/TX pins to your autopilot or controller UART Port.

3. Attach the antenna before powering it ON

Step 2: First Access

1. Connect your PC or mobile device to the AeroTel-24 Wi-Fi network.

   • SSID: AeroTel-24

   • Password: aerotel24 (default, change later)

   • Open a browser and go to: http://192.168.1.1 or Aerotel-24.local

2. The configuration page will load.

Step 3: Configuration Options

• Wi-Fi Mode: AP, Client, Long-Range, BLE (optional)

• SSID/Password: Customize credentials for security

• Channel & IP Settings: Adjust network configuration

• Serial Settings: Select protocol and baud rate

• Advanced Options: Set static IP, Gateway, etc.